Adaptec 29320A-R User Guide - Page 167
Using Driver-specific Parameters
UPC - 760884155226
View all Adaptec 29320A-R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 167 highlights
Adaptec Ultra320 SCSI Cards User's Guide 9 Select Add Value from the Edit menu. In the Value Name edit box, enter one of the valid parameter values. Make sure to enter the appropriate data type for the value. To enter additional values, repeat Steps 8 and 9. Note: Changes made with the Registry Editor do not take effect until you shut down and then restart your computer. Using Driver-specific Parameters To use the Registry Editor to enter adpu320.sys driver-specific parameters that affect the configuration information for Adaptec SCSI PCI device drivers, follow the instructions below. A list of valid parameters follows: Note: The following parameters are case-sensitive and must be entered exactly as shown. When entering multiple parameters, each parameter must be separated by a space. s /MAXTAGS=nnn-specifies the tagged command queue depth per target. If a number is not specified, the tagged queue depth defaults to 32. Valid values are 1-255. The data type for this value is REG_SZ. s /INSTR_ERRLOG_Z=nnn-sets the maximum number of error log entries, if /INSTRUMENTATION is enabled. If a number is not specified, the maximum number or error log entries defaults to 32. Valid values are 0-127. The data type for this value is REG_SZ s /HOTPLUG -enables Hot-Plug PCI feature. If this option is not specified, Hot-Plug PCI feature defaults to disabled. Note: The /HOTPLUG parameter is only supported with Windows NT 4.0. C-4