Adaptec 29320A-R User Guide - Page 108

Adaptec Ultra320 SCSI Cards User's Guide s If the error message persists a Restart your computer system to a DOS prompt again and copy the current versions of adpu320.sys into the %systemroot%\system32\ drivers directory. b Once you've completed this process, remove the floppy disk from drive A and restart your system. Option 2 1 Make a backup copy of disk 3 of the Windows NT 4.0 floppy disk installer set. 2 Copy these files from the Current Driver Set: s DISK1 s TXTSETUP.OEM s ADPU320.SYS s OEMSETUP.INF 3 Use the floppy installer set to begin the express setup and then specify other when asked for type of mass storage controller. The new OEMSETUP.INF should detect your controller and allow you to complete the installation. Option 3 This option assumes you are doing a fresh installation of Windows NT 4.0. 1 Make a Bootable DOS partition on your hard disk drive using Microsoft fdisk.exe 2 GB or less in size and then format the partition with Microsoft format.com. 2 Restart your computer system to a DOS prompt and make a directory in the C drive called I386. 3 Copy all of the contents of the I386 subdirectory on the Windows NT 4.0 CD into the I386 you created on the C drive. 4 Copy the files, TXTSETUP.OEM, ADPU320.SYS and OEMSETUP.INF, from the Ultra320 Family Manager Set (FMS) into the I386 directory on your C drive. 5 Restart the computer (make sure there are no floppy disks or CDs in the computer). 9-10