Adaptec 29320A-R User Guide - Page 43

Adaptec Ultra320 SCSI Cards User's Guide The default settings are appropriate for most systems and should not be changed. Run SCSISelect if you need to change or view current settings, or if you need to use the SCSI disk utilities. See the descriptions of each option, starting on page 3-4. SCSISelect Options SCSI Bus Interface Definitions: SCSI Controller ID SCSI Controller Parity SCSI Controller Termination: Ch. A Available Settings Default Setting 0-15 Enabled Disabled Automatic, Disabled 7 Enabled Automatic Ch. B Automatic, Disabled Automatic Boot Device Configuration Options-BBS Systems Only: Select Master SCSI Controller A, B A [Auto-sync] Boot SCSI Controller [Auto-sync] A, B A Boot Device Configuration-Non-BBS Systems Only: Select Master SCSI Controller A, B A [Auto-sync] Boot SCSI Controller [Auto-sync] A, B A Boot SCSI ID [Auto-sync] 0-15 0 Boot LUN Number1 [Auto-sync] 0-7 0 SCSI Device Configuration Options: Sync Transfer Rate (MB/sec) 320, 160, 80.0, 66.6, 320 40.0, 33.3, 20.0, 10.0, ASYN Packetized Yes, No Yes (Enabled) QAS Yes, No Yes (Enabled) Initiate Wide Negotiation Yes, No Yes (Enabled) Enable Disconnection Yes, No Yes (Enabled) Send Start Unit Command Yes, No Yes (Enabled) BIOS Multiple LUN Support 1 Yes, No No (Disabled) Include in BIOS Scan 2 Yes, No Yes (Enabled) Advanced Configuration: Reset SCSI Bus at IC Initialization Enabled, Disabled Enabled 3-2