Adaptec 29320A-R User Guide - Page 82

Adaptec Ultra320 SCSI Cards User's Guide Installing the Driver for Windows NT 4.0 To begin driver installation, see either Installing the Driver When Installing Windows NT 4.0 on page 6-2 or Installing the Driver When Windows NT 4.0 is Already Installed on page 6-3. Installing the Driver When Installing Windows NT 4.0 To install the a320raid.sys driver when you are installing Windows NT 4.0: Note: During Windows NT 4.0 installation, if your system configuration has multiple arrays and/or single drives, Windows NT 4.0 limits the size of the system partition you can create to 1 GB. 1 Start your system with the Windows NT 4.0 Boot disk in the floppy disk drive or the Windows NT 4.0 Boot CD in the CD-ROM drive. Note: If DOS is installed and you are trying to install Windows NT 4.0, then it may also be necessary to edit the config.sys file to include command lines for your CD-ROM drive. See the system documentation for more information. 2 When the following message appears on-screen, press the F6 key. Setup is inspecting your computer system's hardware... If you are installing from CD, skip to Step 4. If you are installing from floppy disk, continue to Step 3. 3 For Windows NT 4.0 Boot disk installation only: When prompted, insert disk #2 in your floppy disk drive. After a few moments you will see a blue screen. Continue with Step 4. 4 Press S to specify an additional device. 5 Press Enter to select Others; insert the Adaptec HostRAID driver for Windows disk in your floppy disk drive and press Enter. 6-2