Adaptec 29320A-R User Guide - Page 58

Configuring the Adaptec SCSI Card with SCSISelect To view the SCSI IDs: 1 Start SCSISelect. See Starting SCSISelect on page 3-3. SCSISelect detects all Adaptec SCSI cards and displays the model number, channel letter, slot number, and PCI address for each SCSI card and channel. 2 Select the SCSI card and channel that has the devices you want to list. The Options menu appears. 3 Select SCSI Disk Utilities. SCSISelect scans the SCSI bus (to determine the devices installed) and displays a list of all SCSI IDs and the devices assigned to each ID. Adaptec SCSISelect(TM) Utility vX.XX 39320A A at slot 6, 00:0E:00 Select SCSI Disk and press SCSI ID # 0 : SCSI ID # 1 : SCSI ID # 2 : SCSI ID # 3 : SCSI ID # 4 : SCSI ID # 5 : SCSI ID # 6 : SCSI ID # 7 : SCSI ID # 8 : SCSI ID # 9 : SCSI ID # 10 : SCSI ID # 11 : SCSI ID # 12 : SCSI ID # 13 : SCSI ID # 14 : SCSI ID # 15 : Ultra320 Hard Drive HM426EI No device No device No device No device No device No device Adaptec AIC-7902 Ultra320 Hard Drive HM426EI No device No device No device No device No device No device No device move cursor, accept option, exit If a device does not show up in SCSISelect, check these items first: s Is the device attached to the SCSI cable? s Is there power to the device? s Does the device have a unique SCSI ID? If two devices are on the same ID and on the same bus, only one device or none of the devices may show up. To correct this, make sure that each device has a unique SCSI ID. 4 Use the ↑ and ↓ keys to move the cursor to a specific ID and device, then press Enter. 3-17