Adaptec 29320A-R User Guide - Page 178

Adaptec Ultra320 SCSI Cards User's Guide Completing the HostRAID Driver Installation After you have installed the HostRAID driver and enabled HostRAID support, you need to complete the installation so that the Windows operating system can detect the new enabled driver hardware. To complete your HostRAID driver installation, follow these steps: 1 Restart Windows 2000. Windows 2000 will detect the newly enabled HostRAID support and will prompt you for the HostRAID driver. 2 At the Welcome to the Found New Hardware Wizard window, select Next. 3 At the Install Hardware Device Drivers window, select Search for a suitable driver for my device, then click Next. 4 At the Locate Driver Files window, click Next . 5 Click Next again. You may be prompted with this warning message: "The software you are about to install does not contain a Microsoft digital signature..." Ignore the warning and click Yes to continue. 6 Insert the Adaptec Installation CD into the CD-ROM drive when prompted, then click OK. 7 When the driver is copied on the hard disk drive, click Finish. 8 You will be prompted to restart the computer. Select Yes. Note: To migrate the nonboot channel from SCSI to HostRAID, follow the instructions for migrating from a boot channel for your other channel. E-4