Adaptec 29320A-R User Guide - Page 138

Adaptec Ultra320 SCSI Cards User's Guide Installing the Driver When Installing Solaris 9 To install Solaris 9 with an Ultra320 SCSI Host Adapter: 1 Start your installation using one of the following: s Solaris 9 Configuration Assistant Diskette s Solaris 9 Install CD (for Web Jumpstart Installation) s Solaris 9 Software (1 of 2 CDs) Wait until the Solaris Device Configuration Assistant screen is displayed, then press F4 to add the driver (F4_Add Driver). 2 The Install Supplemental Drivers screen is displayed. If you booted off of the Configuration Assistant diskette, replace it with the Adaptec driver disk, otherwise, insert the Adaptec driver disk into the floppy disk drive and press F2 (F2_Continue). (See Appendix B, Windows Error Messages for information on creating driver floppy disks.) 3 On the Select Solaris System Version window, select Solaris OS 2.9 by pressing the Spacebar, then press F2 (F2_Continue). 4 On the Loading Supplemental Driver Software window, you will see a progress bar displaying the status of adpu320.itu being loaded into memory. Then the Continue Supplemental Driver Installation window is displyed. If you need to install other drivers, insert them into the floppy disk drive and press F2 (F2_Continue); otherwise press F4 (F4_Done). 5 The Identified Device Drivers window is displayed. The adpu320 should be one of the identified drivers. Press F2 (F2_Continue). The Solaris Device Configuration Assistant window will be displayed. If you booted off the Configuration Assistant diskette, reinsert it into the floppy disk drive and press F2. Otherwise, just Press F2 (F2_Continue). You will see the Scanning Devices window with a status bar, then the Identified Devices window will be displayed. Among the identified devices, look for the line Adaptec SCSI Card 39320A - Ultra320 SCSI or Adaptec SCSI Card 39320 - Ultra320 SCSI. If it is not there, please check that you have the correct driver and SCSI controller. 12-2