Brother International Innov-ís 1200 Users Manual - English - Page 157

Attaching the Embroidery Frame This section describes how to attach the embroidery frame. Attaching the embroidery frame Wind the embroidery bobbin thread onto the a bobbin and set it into the bobbin case. • For details, refer to "Winding/Installing the Bobbin" (page 23). 1 1 Raise the presser foot lever. b a Lever 1 2 a 4 a Presser foot lever Pass the embroidery frame under the presser c foot while raising the presser foot lever even further. 2 a Mounting brackets b Pins 3 CAUTION ● Do not hit the needle with your finger or the embroidery frame. It may cause injury or needle breakage. While lightly holding the lever on the frame d holder to the left, align the two pins on the embroidery frame holder with the mounting brackets on the frame, and then press the frame into the embroidery frame holder until a click is heard. After pressing the front mounting bracket onto the pin so that it clicks into place, press the back mounting bracket into place. Note z Be sure to insert both pins. If only the forward or the back pin is inserted, the pattern may not turn out correctly. CAUTION ● Correctly set the embroidery frame into the embroidery frame holder. Otherwise, the presser foot may hit the embroidery frame, resulting in injury. Attaching the Embroidery Frame 155