Brother International Innov-ís 1200 Users Manual - English - Page 35

Note Threading the needle manually z If the needle was not completely threaded, but a loop in the thread was formed in the (without using the needle threader) eye of the needle, carefully pull the loop through the eye of the needle to pull out the end of the thread. When using special thread, thread with a thickness of 130/20 or thicker, the wing needle or the twin needle which cannot be used with the needle threader, 1 thread the needle as described below. Thread the machine to the needle bar thread a guide. • For details, refer to "Upper Threading" (page 29). CAUTION ● When pulling out the thread, do not pull it with extreme force, otherwise the needle may break or bend. Lower the presser foot lever. b Raise the presser foot lever, pass the end of the e thread through the presser foot, and then pull out about 5 cm (2 inches) of thread toward the rear of the machine. 1 a Pressor foot lever Pass the thread through the eye of the needle c from front to back. 1 a 5 cm (2 inches) X The upper threading is finished. Now that the upper threading and the lower threading are finished, you are ready to begin sewing. Note z If the needle is not raised, the needle threader cannot thread the needle. Be sure to press ("Needle Position" button) to raise the needle before using the needle threader. Raise the presser foot lever, pass the end of the d thread through the presser foot, and then pull out about 5 cm (2 inches) of thread toward the rear of the machine. Upper Threading 33