Cisco 10720 Configuration Guide - Page 173
Removing a Bale Clasp SFP, Step 1
View all Cisco 10720 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 173 highlights
Chapter 5 Maintaining the Cisco 10720 Internet Router Removing and Installing an Uplink Card Removing a Bale Clasp SFP To remove a bale clasp SFP module from the access card, perform the following steps: Step 1 Attach an ESD-preventive strap to your wrist, and to the router or to a bare metal surface. (See the "Preventing Electrostatic Discharge" section on page 2-3.) Figure 5-52 Optical Interface Cable PWARCSRAXASACPRPTTIKRIHTVEERRU PSCOYOASWVRTEEDERRFMTAEISLMTPAUS 66301 CONSOLE AUX RESET 1 1 Optical interface cable connector Step 2 Remove all optical interface cables from the card if the card has optical interface ports. (See Figure 5-52.) 78-13062-10 Cisco 10720 Internet Router Installation and Configuration Guide 5-51
5-51
Cisco 10720 Internet Router Installation and Configuration Guide
78-13062-10
Chapter 5
Maintaining the Cisco 10720 Internet Router
Removing and Installing an Uplink Card
Removing a Bale Clasp SFP
To remove a bale clasp SFP module from the access card, perform the following steps:
Step 1
Attach an ESD-preventive strap to your wrist, and to the router or to a bare metal surface. (See the
“Preventing Electrostatic Discharge” section on page 2-3
.)
Figure 5-52
Optical Interface Cable
Step 2
Remove all optical interface cables from the card if the card has optical interface ports. (See
Figure 5-52
.)
1
Optical interface cable connector
RESET
CONSOLE
AUX
OVERTEMP
ACTIVE
CARD FAIL
SYSTEM STAUS
POWER
CARRIER
RX PKT
WRAP
PASS THRU
66301
1