Cisco 10720 Configuration Guide - Page 75

Chapter 3 Installing the Cisco 10720 Internet Router Installing the Cable-Management System In-Band Ethernet Port In-band Ethernet is connected to the hub by using one of the Fast Ethernet or Gigabit Ethernet ports on the access card. Out-of-band Ethernet is not available on the Cisco 10720 Internet Router. Installing the Cable-Management System The cable-management system, located on the front of the router, organizes the interface cables. To keep the cables free of sharp bends, extend the cables from the center out both sides of the cable-management system. Excessive bending of an interface cable can degrade performance and possibly harm the cable. Perform the following steps to install the cable-management system: Step 1 Attach an ESD-preventive wrist strap to your wrist, and to the router or to a bare metal surface. (See the "Preventing Electrostatic Discharge" section on page 2-3.) Figure 3-22 Attaching the Cable-Management Tray PWARCSRAXASACPRPTTIKRIHTVEERRU CONSOLE AUX RESET PSCOYOASWVRTEEDERRFMTAEISLMTPAUS AC OK DC OK OTF LINK/A1C00TCIAVMREB (DPGSF)AIL PCOAWREDRFAIL WODITROHNINTNSHOEERTPTROCEWAMEBORLVEOESN AC OK DC OK OTF INPUT 100-200- 50/60Hz 2-5A 66296 Step 2 Attach the cable-management tray to the router using four of the 3.5-mm x 6-mm screws that are shipped with the router. Secure the tray with two screws on each side of the router chassis using a Number 1 Phillips screwdriver. (See Figure 3-22.) Figure 3-23 Managing Router Cables with the Cable-Management Tray PWARCSRAXASACPRPTTIKRIHTVEERRU 57749 CONSOLE AUX RESET PSCOYOASWVRTEEDERRFMTAEISLMTPAUS AC OK DC OK OTF LINK/A1C00TCIAVMREB (DPGSF)AIL PCOAWREDRFAIL WODITROHNINTNSHEOERTPTROCEWAMEBORLVEOESN AC OK DC OK OTF INPUT 100-200- 50/60Hz 2-5A Step 3 Separate cables and lead them out the sides of the cable-management tray. Use a cable tie to keep the cables together. (See Figure 3-23.) 78-13062-10 Cisco 10720 Internet Router Installation and Configuration Guide 3-25