Cisco 10720 Configuration Guide - Page 178

Removing and Installing an Uplink Card Chapter 5 Maintaining the Cisco 10720 Internet Router Installing the OC48 SFP Modules in the RPR/SRP Uplink Card Use the information in this section to install OC48 SFP modules in the RPR/SRP uplink card. Note Use only OC48 SFP modules purchased from Cisco Systems. To install a bale clasp OC48 SFP module in the uplink card, perform the following steps: Step 1 Step 2 Attach an ESD-preventive strap to your wrist, and to the router or to a bare metal surface. (See the "Preventing Electrostatic Discharge" section on page 2-3.) Hold the SFP module with the hardware label facing up, as illustrated in Figure 5-1. Caution The SFP module must be inserted with the hardware label facing up to avoid damaging the SFP module or uplink card. Figure 5-59 Installing the Bale Clasp SFP Module in the RPR/SRP Uplink Card 1 10720-RPR-SFP 1 PPRRCAAXOSACTPSRTEIKTRIVCTHETERRU 122091 10003B0-a1s2e9-L9X-01 2 1 RPR/SRP uplink card 2 OC48 SFP module Step 3 Step 4 Close the bale clasp on the SFP module by pushing the clasp in the upward direction before inserting the SFP module. Insert the SFP into the appropriate OC48 port and gently push on it until the SFP module snaps into the slot. (See Figure 5-59.) 5-56 Cisco 10720 Internet Router Installation and Configuration Guide 78-13062-10