Cisco 10720 Configuration Guide - Page 98

Additional Configuration Features Chapter 3 Installing the Cisco 10720 Internet Router Note The router does not have an available Ethernet Out of Bound Controller (EOBC) management interface. Cisco IOS software images cannot be downloaded from the ROM monitor or while the system is booting up. Perform the following steps to update the Cisco IOS software image: Step 1 Step 2 Step 3 Step 4 Enter the enable command. Router> enable Copy the Cisco IOS software image from the TFTP server to the router Flash memory using the copy tftp flash command. Router# copy tftp flash Address or name of remote host []? tftp_server Source filename []? /tftpboot/ image name Destination filename [file name]? Accessing tftp://tftp_server//tftpboot/ image name !!!!!!! Specify the new Flash memory image using the config terminal command. Router# config terminal Router(config)# boot system flash:image name Router(config)# config-register 0x2102 Restart the router using the reload command. Router# reload Proceed with reload? [confirm] 03:36:32: %SYS-5-RELOAD: Reload requested Note The following commands are presently not supported on a Cisco 10720 Internet Router: boot system tftp , rommon 1>boot , rommon 1>tftpdnld Verifying the Image Is Upgraded Enter the show version command to confirm the correct image is loaded on the router. (See the "Using the show Commands" section on page 3-42.) Upgrading ROM Monitor The following section provides information for upgrading the ROM monitor (ROMmon) image. For additional information about ROMmon features, refer to the Cisco IOS Software Configuration for the Cisco 10720 Internet Router publication. 3-48 Cisco 10720 Internet Router Installation and Configuration Guide 78-13062-10