Cisco 10720 Configuration Guide - Page 188
Installing a Latch GE SFP Module, Installing the Latch SFP Module in the Access Card
View all Cisco 10720 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 188 highlights
Removing and Installing an Access Card Chapter 5 Maintaining the Cisco 10720 Internet Router cage. To remove the SFP module, use a small flathead screwdriver to gently lift the cage tongue (located underneath the SFP module) away from the SFP module body, thus disengaging the SFP module. The SFP module is not damaged by this operation. Step 4 Insert the SFP into the appropriate GE port and gently push on it until the SFP module snaps into the slot. (See Figure 5-59.) Installing a Latch GE SFP Module To install a latch GE SFP module in the access card, perform the following steps: Step 1 Attach an ESD-preventive strap to your wrist, and to the router or to a bare metal surface. (See the "Preventing Electrostatic Discharge" section on page 2-3.) Figure 5-69 Installing the Latch SFP Module in the Access Card 10720-GE-FE-TX 1 LIENRKROARC (TIRV)E (G) 70058 TX RX 10003B0-a1s2e9-9L-X01 2 1 Access card 2 GE SFP module with latch Step 2 Hold the SFP module with the hardware label facing up, as illustrated in Figure 5-69. Caution The SFP module must be inserted with the hardware label facing up to avoid damaging the SFP module or the uplink card. Step 3 Step 4 Insert the SFP into the appropriate RPR/SRP uplink card slot and gently push on it until the module snaps into the slot tightly. (See Figure 5-69.) Close the latch to lock the SFP module into the slot. 5-66 Cisco 10720 Internet Router Installation and Configuration Guide 78-13062-10