Cisco 10720 Configuration Guide - Page 192
Installing the Cable-Management System, Step 1
View all Cisco 10720 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 192 highlights
Removing and Installing the Cable-Management System Chapter 5 Maintaining the Cisco 10720 Internet Router Installing the Cable-Management System Perform the following steps to install the cable-management system: Step 1 Step 2 Power down your router. (See the "Disconnecting Power from the Router" section on page 5-3.) Attach an ESD-preventive wrist strap to your wrist, and to the router or to a bare metal surface. (See the "Preventing Electrostatic Discharge" section on page 2-3.) Figure 5-73 Attaching the Cable-Management Tray PWARCSRAXASACPRPTTIKRIHTVEERRU CONSOLE AUX RESET PSCOYOASWVRTEEDERRFMTAEISLMTPAUS AC OK DC OK OTF LINK/A1C00TCIAVMREB (DPGSF)AIL PCOAWREDRFAIL WODITROHNINTNSHOEERTPTROCEWAMEBORLVEOESN AC OK DC OK OTF INPUT 100-200- 50/60Hz 2-5A 66296 Step 3 Step 4 Attach the cable-management tray to the router using four of the 3.5 mm x 6 mm screws that ship with the router. Secure the tray with two screws on each side of the router chassis. (See Figure 5-73.) Connect all interface cables to their respective ports if necessary. Figure 5-74 Managing Interface Cables with the Cable-Management Tray PWARCSRAXASACPRPTTIKRIHTVEERRU 57749 CONSOLE AUX RESET PSCOYOASWVRTEEDERRFMTAEISLMTPAUS AC OK DC OK OTF LINK/A1C00TCIAVMREB (DPGSF)AIL PCOAWREDRFAIL WODITROHNINTNSHEOERTPTROCEWAMEBORLVEOESN AC OK DC OK OTF INPUT 100-200- 50/60Hz 2-5A Step 5 Separate the cables and lead them out the sides of the cable-management system. Use a cable tie to keep the cables together. (See Figure 5-74.) Note To avoid damage to the cables, avoid excessive bending. 5-70 Cisco 10720 Internet Router Installation and Configuration Guide 78-13062-10