Cisco 10720 Configuration Guide - Page 177
Installing an Uplink Card, Sliding Uplink Card into Router Chassis
View all Cisco 10720 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 177 highlights
Chapter 5 Maintaining the Cisco 10720 Internet Router Removing and Installing an Uplink Card Installing an Uplink Card To install an uplink card, perform the following steps: Step 1 Step 2 Confirm that the router is powered down before installing the uplink card. (See the "Disconnecting Power from the Router" section on page 5-3.) Attach an ESD-preventive strap to your wrist, and to the router or to a bare metal surface. (See the "Preventing Electrostatic Discharge" section on page 2-3.) Figure 5-57 Sliding Uplink Card into Router Chassis 57809 LINK/A1C00TCIAVMREB (DPGSF)AIL PWARCSRAXASACPRPTTIKRIHTVEERRU PSCOYOASWVRTEEDERRFMTAEISLMTPAUS CONSOLE AUX RESET PCOAWREDRFAIL WODITROHNINTNSHEOERTPTROCEWAMEBORLVEOESN Step 3 Step 4 Grasp the card and use the uplink card slot guides to insert the card into the router. Using your hold on the spring-loaded screws located on the front of the uplink card, insert the card into the upper card slot of the router chassis. (See Figure 5-57.) Caution Do not force the card into the slot. Exerting too much force on the card can damage the card or the router. Step 5 Gently slide the card into the router chassis until the card seats into the midplane. Figure 5-58 Turning Spring-Loaded Screws Clockwise 57975 Step 6 Using a 1/8-inch flat-blade screwdriver, tighten the spring-loaded screws by turning them clockwise until the card is completely secure. (See Figure 5-58.) 78-13062-10 Cisco 10720 Internet Router Installation and Configuration Guide 5-55