Cisco 10720 Configuration Guide - Page 191
Removing the Cable-Management Cover, Step 2, Caution
View all Cisco 10720 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 191 highlights
Chapter 5 Maintaining the Cisco 10720 Internet Router Removing and Installing the Cable-Management System Figure 5-71 Removing the Cable-Management Cover PWARCSRAXASACPRPTTIKRIHTVEERRU 66299 CISCO 10720 INTERNET ROUTER CONSOLE AUX RESET PSCOYOASWVRTEEDERRFMTAEISLMTPAUS AC OK DC OK OTF LINK/A1C00TCIAVMREB (DPGSF)AIL PCOAWREDRFAIL WODITROHNINTNSHOEERTPTROCEWAMEBORLVEOESN AC OK DC OK OTF INPUT 100-200- 50/60Hz 2-5A Step 2 Verify that all cables are safely secured before detaching the cable-management cover. If the cable-management cover is not installed, go to Step 4. Caution To avoid accidental damage to router cables or card ports, remove all cables before removing the cable-management tray. Step 3 Step 4 Step 5 Step 6 Remove the cable-management cover from the router by removing the four screws that secure the cover to the router. (See Figure 5-72.) Power down the router. (See the "Disconnecting Power from the Router" section on page 5-3.) Remove cable ties and separate the interface cables if needed to lead the cables into the inside of the cable-management tray. (See Figure 5-75.) Remove all interface cables from their respective ports. Figure 5-72 Removing the Cable-Management Tray PWARCSRAXASACPRPTTIKRIHTVEERRU CONSOLE AUX RESET PSCOYOASWVRTEEDERRFMTAEISLMTPAUS AC OK DC OK OTF LINK/A1C00TCIAVMREB (DPGSF)AIL PCOAWREDRFAIL WODITROHNINTNSHOEERTPTROCEWAMEBORLVEOESN AC OK DC OK OTF INPUT 100-200- 50/60Hz 2-5A 66297 Step 7 Detach the cable-management tray from the router by removing the two 3.5 mm x 6 mm screws on each side of the router. (See Figure 5-72.) 78-13062-10 Cisco 10720 Internet Router Installation and Configuration Guide 5-69