Cisco 10720 Configuration Guide - Page 63
Use only OC48 SFP modules purchased from Cisco Systems., Step 1, Caution
View all Cisco 10720 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
Chapter 3 Installing the Cisco 10720 Internet Router Connecting Ports on the Uplink Cards To connect the ports on the DPT or POS uplink card, or the RPR/SRP uplink card, follow these instructions: Step 1 Step 2 Attach an ESD-preventive wrist strap to your wrist, and to the router or to a bare metal surface. (See the "Preventing Electrostatic Discharge" section on page 2-3.) Verify that the router is turned off and disconnected from its power source. Installing the OC48 SFP Modules in the RPR/SRP Uplink Card Use the information in this section to install OC48 SFP modules in the RPR/SRP uplink card. Note Use only OC48 SFP modules purchased from Cisco Systems. To install a bale clasp OC48 SFP module in the uplink card, perform the following steps: Step 1 Step 2 Step 3 Attach an ESD-preventive strap to your wrist, and to the router or to a bare metal surface. (See the "Preventing Electrostatic Discharge" section on page 2-3.) Pull the SFP cage cover from the SFP cage. Hold the SFP module with the hardware label facing up, as illustrated in Figure 3-14. Caution The SFP module must be inserted with the hardware label facing up to avoid damaging the SFP module or uplink card. 78-13062-10 Cisco 10720 Internet Router Installation and Configuration Guide 3-13