Cisco RV042 Administration Guide - Page 164

Glossary A Term Definition RIPng (RIP next generation) RIPng is an extension of RIPv2 for support of IPv6. (See the information about RIP in this Glossary.) static routing A static route is a pre-determined pathway that a packet must travel to reach a specific host or network. CAUTION: Static routing is a powerful feature that should be used by advanced users only. In many cases, it is better to use dynamic routing because it enables the router to automatically adjust to physical changes in the network's layout. Use cases for static routing include the following: • Some ISPs require static routes to build your routing table instead of using dynamic routing protocols. • You can use static routes to reach peer routers that do not support dynamic routing protocols. • If the router is connected to more than one network or there are multiple routers installed on your network, it may be necessary to set up static routes to enable traffic between them. • You can use static routing to allow users in different IP domain to access the Internet through the router. VLAN (Virtual LAN) A VLAN is a group of endpoints in a network that are associated by function or other shared characteristics. Unlike LANs, which are usually geographically based, VLANs can group endpoints without regard to the physical location of the equipment or users. Cisco RV220W Administration Guide 164