Cisco RV042 Administration Guide - Page 38
Editing a DMZ Connection, Cancel, Subnet, Range - use dmz port
UPC - 745883560530
View all Cisco RV042 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
3 Editing a DMZ Connection Use the Edit DMZ Connection page to specify the settings for your DMZ. DMZ is enabled by default. IPv4 IPv6 The Edit DMZ Connection page appears after you click the Edit icon in the DMZ Setting section of the Network page. NOTE Before navigating away from this page, click Save to save your settings, or click Cancel to undo them. Any unsaved changes are abandoned. If you are using IPv4 addressing, enter the following information: • Subnet: Choose this option to place the DMZ on a different subnet than the WAN (default setting). Enter an IP address and subnet mask for the DMZ. • Range: Choose this option to place the DMZ on the same subnet as the WAN. Enter the range of IP addresses to reserve for the DMZ port. Cisco Small Business RV0xx Series Routers Administration Guide 38