Cisco WS-C2960S-24TS-S Hardware Installation Guide - Page 57
Installation Guidelines, Switch Installation 24- and 48-Port Switches., Appendix
View all Cisco WS-C2960S-24TS-S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Chapter 3 Switch Installation (8-Port Switches) Preparing for Installation Warning This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the absence of a suitably installed ground conductor. Contact the appropriate electrical inspection authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024 Warning Ultimate disposal of this product should be handled according to all national laws and regulations. Statement 1040. Warning For connections outside the building where the equipment is installed, the following ports must be connected through an approved network termination unit with integral circuit protection: 10/100/1000 Ethernet. Statement 1044 Warning When installing or replacing the unit, the ground connection must always be made first and disconnected last. Statement 1046 Warning No user-serviceable parts inside. Do not open. Statement 1073 Warning Installation of the equipment must comply with local and national electrical codes. Statement 1074 Installation Guidelines This section is specific to the Catalyst 2960 8-port switches. For information applicable to the other Catalyst 2960 switches, see Chapter 2, "Switch Installation (24- and 48-Port Switches)." When you determine where to place the switch, be sure to observe these requirements: • The operating environment must be within the ranges listed in Appendix A, "Technical Specifications." • Airflow around the switch and through the vents must be unrestricted. We strongly recommend that you allow at least 3 inches (7.6 cm) of clearance around the ventilation openings. • Temperature around the unit does not exceed 113°F (45°C). If the switch is installed in a closed environment or in a multirack assembly, the temperature around it might be greater than normal room temperature. • Humidity around the switch must not exceed 85 percent. • Altitude at the installation site must not be greater than 10,000 feet (3,049 meters). • The bottom of the switch might be hot to the touch if the switch is operating at its maximum temperature 113°F (45°C) and is in an environment that exceeds normal room temperature (such as in a closet, in a cabinet, or in a closed or multirack assembly). • Do not place any items on the top of the switch. OL-7075-09 Catalyst 2960 Switch Hardware Installation Guide 3-3