D-Link DES-3010PA-TAA CLI Guide - Page 101
garp timer, GVRP Commands, Syntax, Parameters, Default Configuration, Command Mode, User Guidelines
UPC - 790069296567
View all D-Link DES-3010PA-TAA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 101 highlights
GVRP Commands garp timer The garp timer Interface Configuration (Ethernet, Port channel) mode command adjusts the values of the join, leave and leaveall timers of GARP applications. To return to the default configuration, use the no form of this command. Syntax garp timer {join | leave | leaveall} timer_value no garp timer Parameters • {join | leave | leaveall} - Indicates the type of timer. • timer_value - Timer values in milliseconds in multiples of 10. (Range: 10-2147483640) Default Configuration Following are the default timer values: • Join timer - 200 milliseconds • Leave timer - 600 milliseconds • Leaveall timer - 10000 milliseconds Command Mode Interface configuration (Ethernet, port-channel) mode User Guidelines The following relationship must be maintained between the timers: Leave time must be greater than or equal to three times the join time. Leave-all time must be greater than the leave time. Set the same GARP timer values on all Layer 2-connected devices. If the GARP timers are set differently on Layer 2-connected devices, the GARP application will not operate successfully. Example The following example sets the leave timer for Ethernet port 6 to 900 milliseconds. Console(config)# interface ethernet 6 Console(config-if)# garp timer leave 900 Page 100