D-Link DES-3010PA-TAA CLI Guide - Page 81
mdix
UPC - 790069296567
View all D-Link DES-3010PA-TAA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
Ethernet Configuration Commands mdix The mdix Interface Configuration (Ethernet) mode command enables cable crossover on a given interface. To disable cable crossover, use the no form of this command. Syntax mdix {on | auto} no mdix Parameters • on - Manual mdix • auto - Automatic mdi/mdix Default Configuration The default setting is auto. Command Mode Interface Configuration (Ethernet) mode User Guidelines Auto: All possibilities to connect a PC with cross or normal cables are supported and are automatically detected. On: It is possible to connect to a PC only with a normal cable and to connect to another device only with a cross cable. This is true, if only one device is to be configured: mdix on. To configure another device: no mdix. No: It is possible to connect to a PC only with a cross cable and to connect to another device only with a normal cable. To connect and configure two devices using no mdix, use a cross cable. Example In the following example, automatic crossover is enabled on port 5. Console(config)# interface ethernet 5 Console(config-if)# mdix auto Page 80