D-Link DES-3010PA-TAA CLI Guide - Page 62
sntp server
UPC - 790069296567
View all D-Link DES-3010PA-TAA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
D-Link DES-3010FA/GA/PA CLI Reference Guide sntp server The sntp server Global Configuration mode command configures the device to use the Simple Network Time Protocol (SNTP) to request and accept SNTP traffic from a specified server. To remove a server from the list of SNTP servers, use the no form of this command. Syntax sntp server {ip-address | hostname}[poll] [key keyid] no sntp server host Parameters • ip-address - IP address of the server. • hostname - Hostname of the server. (Range: 1-158 characters) • poll - Enable polling. • keyid - Authentication key to use when sending packets to this peer. (Range:1-4294967295) Default Configuration No servers are defined. Command Mode Global Configuration mode User Guidelines Up to 8 SNTP servers can be defined. Use the sntp unicast client enable Global Configuration mode command to enable predefined unicast clients globally. To enable polling you should also use the sntp unicast client poll Global Configuration mode command for global enabling. Polling time is determined by the sntp client poll timer Global Configuration mode command. Examples The following example configures the device to accept SNTP traffic from the server on 192.1.1.1. Console(config)# sntp server 192.1.1.1 Page 61