D-Link DES-3010PA-TAA CLI Guide - Page 350
dot1x multiple-hosts
UPC - 790069296567
View all D-Link DES-3010PA-TAA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 350 highlights
D-Link DES-3010FA/GA/PA CLI Reference Guide dot1x multiple-hosts The dot1x multiple-hosts Interface Configuration mode command enables multiple hosts (clients) on an 802.1Xauthorized port, where the authorization state of the port is set to auto. To return to the default configuration, use the no form of this command. Syntax dot1x multiple-hosts no dot1x multiple-hosts Default Configuration Multiple hosts are Enabled. Command Mode Interface Configuration (Ethernet) mode User Guidelines This command enables the attachment of multiple clients to a single 802.1X-enabled port. In this mode, only one of the attached hosts must be successfully authorized for all hosts to be granted network access. If the port becomes unauthorized, all attached clients are denied access to the network. For unauthenticated VLANs, multiple hosts are always enabled. Multiple-hosts must be enabled to enable port security on the port. Examples The following command enables multiple hosts (clients) on an 802.1X-authorized port. Console(config)# interface ethernet 6 Console(config-if)# dot1x multiple-hosts Page 349