D-Link DES-3010PA-TAA CLI Guide - Page 79
negotiation
UPC - 790069296567
View all D-Link DES-3010PA-TAA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
Ethernet Configuration Commands negotiation The negotiation Interface Configuration (Ethernet, port-channel) mode command enables auto-negotiation operation for the speed and duplex parameters of a given interface. To disable auto-negotiation, use the no form of this command. Syntax negotiation [capability1 [capability2...capability5]] no negotiation Parameters • capability - Specifies the capabilities to advertise. (Possible values: 10h, 10f, 100h,100f, 1000f) Default Configuration Auto-negotiation is enabled. If unspecified, the default setting is to enable all capabilities of the port. Command Mode Interface Configuration (Ethernet, port-channel) mode User Guidelines If capabilities were specified when auto-negotiation was previously entered, not specifying capabilities when currently entering auto-negotiation overrides the previous configuration and enables all capabilities. Example The following example enables auto-negotiation on Ethernet port 5. Console(config)# interface ethernet 5 Console(config-if)# negotiation Page 78