D-Link DXS-3600-EM-8T CLI Guide - Page 139

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide Display Parameters Gateway Metric LocPrf Weight Path Description IP address of the next router that is used when forwarding a packet to the destination network. An entry of 0.0.0.0 indicates that the router has some non-BGP routes to this network. If shown, this is the value of the inter-autonomous system metric. This field is frequently not used. Local preference value as set with the set local-preference route-map configuration command. The default value is 100. Weight of the route as set via autonomous system filters. Autonomous system paths to the destination network. 7-76 show ip bgp confederation This command is used to display the confederation configuration of BGP. show ip bgp confederation Parameters Default Command Mode Command Default Level Usage Guideline None. None. Privileged Mode. Level: 3. (EI Mode Only Command) Use this command to display the detail of the confederation configured. Example This example shows how to show the current settings of confederation. DXS-3600-32S#show ip bgp confederation BGP AS Number : 200 Confederation Identifier : 10 Confederation Peer : 201, 202 Neighbor List: IP Address Remote AS Number 10.1.1.1 200 172.18.1.1 201 192.168.1.1 202 DXS-3600-32S# Display Parameters BGP AS Number Confederation Identifier Confederation Peer Neighbor List IP Address Remote AS Number Description Indicates the AS number of the local BGP. Indicates the confederation Identifier of the local BGP. Indicates the sub-AS numbers in the same confederation. List all the neighbors in the local BGP router. Indicates the IP address of the neighbors. AS number of the neighbor. 7-77 show ip bgp dampening dampened-paths This command is used to display routes that were dampened by BGP. show ip bgp dampening dampened-paths [vrf VRF-NAME] 131