D-Link DXS-3600-EM-8T CLI Guide - Page 320

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide lldp reinit-delay seconds no lldp reinit-delay Parameters seconds Specifies a delay for LLDP initialization on an interface. Valid values are from 1 to 10 seconds. Default Command Mode Command Default Level Usage Guideline 2 seconds. Global Configuration Mode. Level: 12 A re-enabled LLDP physical interface will wait for reinit-delay after last disable command before reinitializing. Example This example shows how to set the re-init delay interval to 5 seconds. DXS-3600-32S#configure terminal DXS-3600-32S(config)#lldp reinit-delay 5 DXS-3600-32S(config)# Example This example shows how to set the re-init delay interval to default value. DXS-3600-32S#configure terminal DXS-3600-32S(config)#no lldp reinit-delay DXS-3600-32S(config)# 32-7 lldp notification-interval This command is used to set the the timer of the notification interval for sending notifications to configured SNMP trap receiver(s). Use the no form of this command to return to the default settings. lldp notification-interval seconds no lldp notification-interval Parameters seconds Specifies the timer of the notification interval for sending notifications to configured SNMP trap receiver(s). Valid values are from 5 to 3600 seconds. Default Command Mode Command Default Level Usage Guideline 5 seconds. Global Configuration Mode. Level: 12 Globally change the interval between successive LLDP change notifications generated by the switch. Example This example shows how to set the notification interval to 10 seconds. DXS-3600-32S#configure terminal DXS-3600-32S(config)#lldp notification-interval 10 DXS-3600-32S(config)# Example This example shows how to set the notification interval to default value. DXS-3600-32S#configure terminal DXS-3600-32S(config)#no lldp notification-interval DXS-3600-32S(config)# 312