D-Link DXS-3600-EM-8T CLI Guide - Page 310

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide 30-3 speed This command is used to set the speed at which the terminal transmits packets, execute the speed speed command in the line configuration mode. To restore the speed to its default value, run the no speed command. speed speed no speed Parameters speed Specifies the transmission rate (bps) on the terminal. For serial ports, the optional rates are 9600, 19200, 38400, and 115200 bps. The default rate is 115200 bps. Default Command Mode Command Default Level Usage Guideline The default rate is 115200. Line Configuration Mode. Level: 15 This command sets the speed at which the terminal transmits packets. It is only applicable for serial ports. Example This example shows how to configure the rate of the serial port to 115200 bps. DXS-3600-32S#configure terminal DXS-3600-32S(config)#line console DXS-3600-32S(config-line)#speed 115200 DXS-3600-32S(config-line)# 30-4 show line This command is used to show the configuration of a line. show line {console | telnet | ssh} Parameters console telnet ssh Displays the configuration of a console line. Displays the configuration of a telnet line. Displays the configuration of a telnet line. Default Command Mode Command Default Level Usage Guideline None. Privileged EXEC Mode. Level: 15 This command shows the configuration information of a line. Example This example shows the configuration of console port. DXS-3600-32S#show line console Type: Speed: Timeout: console 115200 0 hour 10 min 0 sec DXS-3600-32S# 302