D-Link DXS-3600-EM-8T CLI Guide - Page 425

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide Password Recovery Commands The first two commands, listed in this chapter, are only available when the user enters the Password Recovery mode. For more information about how to access the Password Recovery mode, see "Appendix A - Password Recovery Procedure" on page 664. 41-1 clear This command is used to clear the password, username or password on the current device. clear {levelpassword | username | configure} Parameters levelpassword username configure Specifies to clear the password for each level. Specifies to clear all the usernames and passwords on the device and set the line authentication to no login local, no login, and no login authentication at the same time. Specifies to clear all the configurations on the DUT. Default Command Mode Command Default Level Usage Guideline None. EXEC Mode in Password Recovery Mode. Level: 1 When the password is lost, or the username information is lost, the user can enter the password recovery mode and use this command to clear the level, clear the username or clear the configuration. Example >clear configure > This example shows how to clear the configuration to factory default settings. Example >clear levelpassword > This example shows how to clear the level password to factory default settings. Example >clear username > This example shows how to clear the local authentication database to factory default settings. 41-2 reload This command is used to reboot the switch. reload Parameters Default Command Mode Command Default Level Usage Guideline None. None. EXEC Mode in Password Recover Mode. Level: 1 Used to reboot the switch. 417