D-Link DXS-3600-EM-8T CLI Guide - Page 563

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide Command Default Level Usage Guideline Level: 8 In both the date and repeating forms of the command, the first part of the command specifies when summer time begins, and the second part specifies when it ends. All times are relative to the local time zone. The start time is relative to standard time. The end time is relative to summer time. If the starting month is chronologically after the ending month, the system assumes that you are in the southern hemisphere. You can verify your settings by entering the show clock command. Example This example shows how to specify that the summer time starts on the first Sunday in April at 2 a.m. and ends on the last Sunday in October at 2 a.m. DXS-3600-32S#configure terminal DXS-3600-32S(config)#clock summer-time repeating 1 sun 4 2:00 last sun 10 2:00 DXS-3600-32S(config)# Example This example shows how to specify the exact date and time. In the following example, the daylight saving time (summer time) is configured to start on 2011 October 12 at 2 a.m., and end on 2012 April 26 at 2 a.m. DXS-3600-32S#configure terminal DXS-3600-32S(config)#clock summer-time date 12oct2011 2:00 26apr2012 2:00 DXS-3600-32S(config)# 56-8 show clock This command is used to display the time and date from the system clock. show clock [detail] Parameters detail (Optional) Specifies the clock source (NTP, SNTP, hardware clock, and so on) and the current summer-time setting (if any). Default Command Mode Command Default Level Usage Guideline None. Privileged EXEC Mode. Level: 3 Use this command to show clock setting, time zone setting and summer time setting. Example This example shows the output from the show clock command. DXS-3600-32S#show clock detail Current Time Source : System Clock Boot Time : 23 Dec 2011 05:40:42 Current Time : 23 Dec 2011 06:56:25 Time Zone : UTC -08:00 Summer Time : Date Date From : 12 Oct 2011 02:00 To : 26 Apr 2012 02:00 Offset In Minutes : 60 DXS-3600-32S# 555