D-Link DXS-3600-EM-8T CLI Guide - Page 304

Usage Guideline DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide This command is used to display the multicast routing entries learned on the switch or the multicast static routes created on the switch. You can specify the parameter to display the information that you concerning. If no parameter is specified, all IP multicast routing entries learned on the switch will be displayed. Example This example shows how to display multicast route brief information. DXS-3600-32S#show ip mroute summary IP Multicast Routing Table: 2 entries Flags: D - Dense, S - Sparse, V - DVMRP Timers: Uptime/Expires (10.10.1.52, 224.0.1.3), vlan1, 00:01:32/00:03:20, Flags: D (20.1.1.1, 228.10.2.1), vlan10, 00:05:10/00:03:11, Flags: S DXS-3600-32S# Example This example shows how to display all IP multicast routing information on the system. DXS-3600-32S#show ip mroute IP Multicast Routing Table Flags: D - Dense, S - Sparse, V - DVMRP, s - SSM Group, F - Register flag P - Pruned, R - (S, G) RPT-bit set, T - SPT-bit set Outgoing interface flags: W - Assert winner Timers: Uptime/Expires (10.71.57.210, 235.0.0.4), 00:02:53/00:00:37, flags: ST Incoming interface: vlan1, RPF Neighbor 1.2.0.1 Outgoing interface List: vlan3, Forwarding 00:00:04/00:04:20 (20.2.2.10, 239.0.0.5), 00:02:53/00:00:37, flags: VP Incoming interface: vlan20, RPF Neighbor 2.3.0.1 Outgoing interface List: NULL (30.9.7.4, 237.0.0.6), 00:02:53/00:00:37, flags: D Incoming interface: vlan30, RPF Neighbor 6.2.3.2 Outgoing interface List: vlan5, Forwarding 00:01:21/00:02:39 Total Entries: 3 DXS-3600-32S# Example This example shows how to display IP multicast routing information learned by PIM sparse mode. DXS-3600-32S#show ip mroute sparse (10.1.57.1, 235.0.0.0), 00:00:04/00:03:26, flags: ST Incoming interface: vlan1, RPF Neighbor NULL Outgoing interface list: vlan4, Forwarding 00:00:04/00:04:20 Total Entries: 1 DXS-3600-32S# 296