D-Link DXS-3600-EM-8T CLI Guide - Page 319

Usage Guideline DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide This parameter is a multiplier on the msgTxInterval that used to compute the TTL value of txTTL in an LLDPDU. The TTL will be carried in the LLDPDU packet. The lifetime will be the minimum of 65535 and (message_tx_interval * message_tx_hold_multiplier). At the partner switch, when the TTL for a given advertisement expires, the advertised data is deleted from the neighbor switch's MIB. Example This example shows how to set the LLDP message-tx-hold-multiplier to 3. DXS-3600-32S#configure terminal DXS-3600-32S(config)#lldp message-tx-hold-multiplier 3 DXS-3600-32S(config)# Example This example shows how to set the LLDP message-tx-hold-multiplier to the default value. DXS-3600-32S#configure terminal DXS-3600-32S(config)#no lldp message-tx-hold-multiplier DXS-3600-32S(config)# 32-5 lldp tx-delay This command is used to set the minimum time (delay-interval), any LLDP port will delay advertising successive LLDP advertisements due to a change in LLDP MIB content. The tx-delay defines the minimum interval between sending of LLDP messages due to constantly change of MIB content. Use the no form of this command to return to the default settings. lldp tx-delay seconds no lldp tx-delay Parameters seconds Specifies a delay for sending successive LLDPDU on an interface. Valid values are from 1 to 8192 seconds. Default Command Mode Command Default Level Usage Guideline 2 seconds. Global Configuration Mode. Level: 12 The LLDP message TX interval (transmit interval) must be greater than or equal to 4 times the TX delay interval). Example This example shows how to set the TX delay interval to 8 seconds. DXS-3600-32S#configure terminal DXS-3600-32S(config)#lldp tx-delay 8 DXS-3600-32S(config)# Example This example shows how to configure the TX delay interval to default value. DXS-3600-32S#configure terminal DXS-3600-32S(config)#no lldp tx-delay DXS-3600-32S(config)# 32-6 lldp reinit-delay This command is used to set the minimum time of the re-initialization delay interval on the switch. Use the no form of this command to return to the default settings. 311