D-Link DXS-3600-EM-8T CLI Guide - Page 533

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide Example This example shows how to add a match command to match a BGP community list. DXS-3600-32S(config)#ip community-list standard A-COMMUNITY permit 101:1 DXS-3600-32S(config)#route-map rmap1 permit 10 DXS-3600-32S(config-route-map)#match community A-COMMUNITY exact DXS-3600-32S(config-route-map)# 53-4 match extcommunity This command is used to add a match command to match a Border Gateway Protocol (BGP) extended community (extcommunity) list. Use the no form of this command to delete the match command with BGP extended community list. match extcommunity EXTCOMMUNITY-LIST-NAME no match extcommunity Parameters EXTCOMMUNITY-LISTNAME Specifies the name of the BGP extended community list. The length is up to 16 characters. Default Command Mode Command Default Level Usage Guideline None. Route Map Configuration Mode. Level: 8. (EI Mode Only Command) The BGP extended community list is created with the command ip extcommunity-list. Only one community list is supported. If this command is executed with a different community list, the old one will be overwritten. You can verify your settings by entering the show route-map command. Example This example is used to add a match command to match a BGP extended community list. DXS-3600-32S#configure terminal DXS-3600-32S(config)# ip extcommunity-list standard EXTCOM permit rt 192.168.1.1:100 DXS-3600-32S(config)# route-map rmap1 permit 10 DXS-3600-32S(config-route-map)# match extcommunity EXTCOM DXS-3600-32S(config-route-map)# 53-5 match interface This command is used to add a match command to match the outgoing interface of routes. Use the no form of this command to delete the match command with outgoing interface of routes. match interface ipif_name no match interface Parameters ipif_name Specifies the name of the outgoing interface of routes. Default Command Mode Command Default Level None. Route Map Configuration Mode. Level: 8 525