D-Link DXS-3600-EM-8T CLI Guide - Page 311

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide Link Aggregation Commands 31-1 aggregateport load-balance This command is used to specify the load-balance algorithm. Use the no command to return it to the default setting. aggregateport load-balance {dst-mac | src-mac | src-dst-mac | dst-ip | src-ip | src-dst-ip} no aggregateport load-balance Parameters dst-mac src-mac src-dst-mac dst-ip src-ip src-dst-ip Specifies that the switch should examine the MAC destination address. Specifies that the switch should examine the MAC source address. Specifies that the switch should examine the MAC source and destination address. Specifies that the switch should examine the IP destination address. Specifies that the switch should examine the IP source address. Specifies that the switch should examine the IP source and destination address. Default Command Mode Command Default Level Usage Guideline Traffic is distributed according to the destination and source MAC addresses of the packets. Global Configuration Mode. Level: 15 None. Example This example shows how to configure global load balance. DXS-3600-32S#configure terminal DXS-3600-32S(config)#aggregateport load-balance src-mac DXS-3600-32S(config)# 31-2 lacp port-priority This command is used to set the LACP port priority. Use the no form of this command to return to the default value. lacp port-priority port-priority no lacp port-priority Parameters port-priority Specifies the port priority, in the range of 0-65535. Default Command Mode Command Default Level Usage Guideline By default, the port priority is 32768. Interface Configuration Mode. Level: 15 The LACP port-priority interface configuration command determines which ports are bundled. In port-priority comparisons, a numerically lower value has a higher priority. If two or more ports have the same LACP port priority (for example, they are configured with the default setting of 32768), lower port number has higher priority. 303