D-Link DXS-3600-EM-8T CLI Guide - Page 607

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide Traffic Segmentation Commands 64-1 switchport protected unidirectional This command is used to enable the interface isolated to a specified interface list for unidirectional protected. Use the no form of the command to disable the interface isolated to a specified interface list. switchport protected unidirectional {interface-type interface-list} no switchport protected unidirectional [interface-type interface-list] Parameters interface-type interface-list Specifies the interface type, such as fastEthernet, gigabitEthernet and tenGigabitEthernet. Specifies the interface list. Default Command Mode Command Default Level Usage Guideline The main interface is not isolated. Interface Configuration Mode. Level: 15 After the interface is isolated to a specified interface, the interface can not switch on L2 and route on L3 to the specified interface. But the specified interface to it has no limit. If not specified, all interfaces will be included. Use the show protected-ports command to display unidirectional configuration. Example This example shows how to enable the port 1 isolated to port 2-6. DXS-3600-32S#configure terminal DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1 DXS-3600-32S(config-if)#switchport protected unidirectional tenGigabitEthernet 1/0/2-1/0/6 Success DXS-3600-32S(config-if)# 64-2 show protected-ports This command is used to display the switch port's protected configuration information. show protected-ports interface interface-id Parameters interface interface-id Displays the specified interface's unidirectional isolated information. Default Command Mode Command Default Level Usage Guideline None. Privileged Mode. Level: 15 This command is used to display the switch port's protected configuration information. 599