D-Link DXS-3600-EM-8T CLI Guide - Page 463

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide 47-8 ip pim spt-threshold This command is used to configure the condition to switchover to the source tree. To restore the default setting, use no form of this command. ip pim spt-threshold {0 | infinity} no ip pim spt-threshold Parameters 0 infinity Specifies to establish the source tree right at the arrival of the first packet. Specifies to always relay on the shared tree. Default Command Mode Command Default Level Usage Guideline Infinity. Global Configuration Mode. Level: 8. (EI Mode Only Command) Use this command on the last hop of the router. In PIM-SM mode, initially the multicast traffic from the source will be flowing along the RPT share tree to the receiver. After the first packet arrives at the last hop router, for each group of traffic, it can operate in one of the following two modes. With mode "infinity", the traffic keeps following the share tree. With mode "0", the source tree will be established and the traffic switchover to the source tree. To verify your configuration, use command show ip pim. Example This example shows how to configure the PIM to work in the SPT mode at the arrival of the first packet. DXS-3600-32S#configure terminal DXS-3600-32S(config)#ip pim spt-threshold 0 DXS-3600-32S(config)# Example This example shows how to configure the PIM to always work in the RPT mode. DXS-3600-32S#configure terminal DXS-3600-32S(config)#no ip pim spt-threshold DXS-3600-32S(config)# 47-9 ip pim rp-register-kat This command is used to configure the keep alive time when RP receiving a register message. To restore default value, use no form of this command. ip pim rp-register-kat SECONDS no ip pim rp-register-kat Parameters SECONDS Specifies the keep alive time, in the range 1 to 65525 seconds Default Command Mode Command Default Level 185 seconds. Global Configuration Mode. Level: 8. (EI Mode Only Command) 455