D-Link DXS-3600-EM-8T CLI Guide - Page 553

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide 55-9 snmp-server community This command is used to set up the community access string to permit access to the SNMP. Use the no command to remove the specified community string, snmp-server community COMMUNITY-STRING view VIEW-NAME {ro | rw} no snmp-server community COMMUNITY-STRING Parameters COMMUNITY-STRING view VIEW-NAME ro rw Specifies the community string that consists of from 1 to 32 alphanumeric characters and functions much like a password, permitting access to the SNMP protocol. Blank spaces are not permitted in the community string. The syntax is general string that does not allow space. (Optional) Specifies the name of a previously defined view. The view defines the objects available to the SNMP community. (Optional) Specifies read-only access. Authorized management stations are only able to retrieve MIB objects. (Optional) Specifies read-write access. Authorized management stations are able to both retrieve and modify MIB objects. Default Command Mode Command Default Level Usage Guideline There are two communities in the default as following: Community Name: private Community Index: private Community SecurityName: private Storage-type: nonVolatile active Community Name: public Community Index: public Community SecurityName: public Storage-type: nonVolatile active Global Configuration Mode. Level: 12 This command creates a community name entry in the community name table. Example This example shows how to create SNMP community called 'comaccess' with view mib2. DXS-3600-32S#configure terminal DXS-3600-32S(config)#snmp-server community comaccess view mib2 rw DXS-3600-32S(config)# Example This example shows how to remove the SNMP community called 'comaccess'. DXS-3600-32S#configure terminal DXS-3600-32S(config)#no snmp-server community comaccess DXS-3600-32S(config)# 55-10 snmp-server enable traps This command is used to enable all Simple Network Management Protocol (SNMP) notification types that are available on your system, use the snmp-server enable traps command in global configuration mode. To disable all available SNMP notifications, use the no form of this command. snmp-server enable traps 545