D-Link DXS-3600-EM-8T CLI Guide - Page 268

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide ip igmp robustness-variable number no ip igmp robustness-variable Parameters number Specifies the value of robustness variable, ranging 1 to 7. Default Command Mode Command Default Level Usage Guideline The default value is 2. Interface Configuration Mode. Level: 8. (EI Mode Only Command) The Robustness Variable allows tuning for the expected packet loss on a network. If a network is expected to be lossy, the Robustness Variable may be increased. IGMP is robust to (Robustness Variable - 1) packet losses. Use the show ip igmp interface command to verify your setting. Example This example shows how to set the value of robustness variable to 3 on the interface VLAN 1. DXS-3600-32S#configure terminal DXS-3600-32S(config)#interface vlan 1 DXS-3600-32S(config-if)#ip igmp robustness-variable 3 DXS-3600-32S(config-if)# 23-7 ip igmp version This command is used to set the version number of IGMP to be used on the interface. Use the no form of this command to restore it to the default value. ip igmp version {1 | 2 | 3} no ip igmp version Parameters {1 | 2 | 3} Specifies three version numbers, ranging 1 to 3. Default Command Mode Command Default Level Usage Guideline The default value is 3. Interface Configuration Mode. Level: 8. (EI Mode Only Command) Use this command to globally configure the IGMP version. We recommend that all devices on the subnet support the same IGMP version. Use the show ip igmp interface command to verify your setting. Example This example shows how to set the version number to 2 on the interface VLAN 1:. DXS-3600-32S#configure terminal DXS-3600-32S(config)#interface vlan 1 DXS-3600-32S(config-if)#ip igmp version 2 DXS-3600-32S(config-if)# 260