D-Link DXS-3600-EM-8T CLI Guide - Page 528

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide timer basic update timeout garbage_collection no timer basic Parameters update timeout garbage_collection Specifies the rate (in seconds) at which updates are sent. The value range is 5 to 65535. Specifies the interval of time (in seconds) after which a route is declared invalid. A route becomes invalid when there is an absence of updates that refresh the route. The invalid route is put in the garbage list, marked as inaccessible, and advertised as unreachable. The value range is 5 to 65535. Specifies the amount of time (in seconds) that must pass before the route is removed from the garbage list. Before timeout, the entry is advertised as unreachable. The value range is 5 to 65535. Default Command Mode Command Default Level Usage Guideline By default, the update time is 30 seconds, the timeout time is 180 seconds and the garbage_collection time is 120 seconds Router Configuration Mode. Router Address Family Configuration Mode. Level: 8. (EI Mode Only Command) The basic timers' parameters for RIP are adjustable. Although the RIP protocol does not require the router process RIP protocol with same basic timers, otherwise RIP is executing a distributed, asynchronous routing algorithm These timers are suggested to be the same for all routers and access servers in the network. In this command, we don't check that if the update timer is bigger than timeout timer, the user should configure the update timer bigger than timeout timer to ensure RIP to work normally. You can verify your settings by entering the show ip rip command. Example This example shows how to configure the RIP update time to 20 seconds, the timeout time to 180 seconds, and the garbage collection time to 100. DXS-3600-32S#configure terminal DXS-3600-32S(config)#router rip DXS-3600-32S(config-router)#timer basic 20 180 100 DXS-3600-32S(config-router)# Example This example shows how to configure RIP update time to 40 seconds, timeout time to 120 seconds, and garbage collection time to 120 in VRF VPN-A. DXS-3600-32S#configure terminal DXS-3600-32S(config)#router rip DXS-3600-32S(config)#address-family ipv4 vrf VPN-A DXS-3600-32S(config-router-af)#timer basic 40 120 120 52-16 version This command is used to configure the default version for all RIP interfaces to send or receive RIP packets. Use the no form of this command to restore to the default value. version {1 | 2} no version 520