Dell 5310n Mono Laser Printer User's Guide - Page 56
Custom Types, Universal Setup, Bin Setup
View all Dell 5310n Mono Laser Printer manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Vinyl Labels Loading Bond Loading Letterhead Loading Preprinted Loading Colored Loading Card Stock Loading Custom Loading single-sided job. Off* Properly handles preprinted card stock whether the job is a duplexed or Duplex Shown if Card Stock is supported in the specified single-sided job. Off* input source. Properly handles preprinted custom paper whether the job is a duplexed Duplex Shown if the custom type is supported in the or single-sided job. Off* specified input source. Custom Types This menu selection is used to define a name for each custom paper type. You can assign names from the operator panel. Menu selection: Custom Type N Purpose: Values: Specifies the type of paper associated with each Custom Type available in the Paper Type menu. Paper* The custom type media must be supported in the input source you Card Stock designate in order to assign a user-defined name. Transparency Labels Vinyl Labels Envelope Once the name is assigned, the name (truncated to 16 characters) will be displayed instead of Custom Type x. Universal Setup This menu selection is used to specify the height and width of the Universal Paper Size. By specifying the height and width for Universal Paper Size, the printer will use the Universal setting exactly like other paper sizes, including support for duplex and n-up. Menu selection: Units of Measure Portrait Width Portrait Height Feed Direction Purpose: Values: Determines the unit of measure used to enter the Universal Height and Width. Sets the portrait width of the universal media. NOTE: If the value set exceeds the maximum width, the printer will use the maximum value allowed in inches or millimeters. Sets the portrait height of the universal media. NOTE: If the value set exceeds the maximum height, the printer will use the maximum value allowed in inches or millimeters. Inches Millimeters 3 inches to 14.17 inches in 0.01 inch increments (76 mm to 360 mm in 1 mm increments) 3 inches to 14.17 inches in 0.01 inch increments (76 mm to 360 mm in 1 mm increments) Specifies the feed direction of the Universal Paper Size. Short Edge* Long Edge Inches is US default; Millimeters is international default. Shows either inches or millimeters from Units of Measure setting; 8.5 inches is the US default, and 216 mm is the international default. Shows either inches or millimeters from Units of Measure setting; 14 inches is the US default, 356 mm is the international default. Long Edge is only shown if the longest edge is shorter than the Maximum Physical Width of the printer. Bin Setup This menu selection is used to specify the output bin where you want your printed material to go to. NOTE: Bin Setup is only displayed when at least one optional output bin is installed. Menu Purpose: selection: Output Bin Specifies the default bin for printed material. Values: Standard Bin* Bin l If a user-defined name is available, it appears instead of Bin . l The name is truncated to 14 characters. l If two or more bins share the same name, the name only appears once in the Output Bin value list. Configure Bins Determines which output bin(s) the printer uses for a particular Mailbox job. Link* Mail Overflow Sends print jobs to the output bin designated for that user. Links two or more bins together as though they were one large bin. When one linked bin is full, the printer starts filling the next linked bin, and continues with each additional linked bin. Sends print jobs to the output bin designated for that