Dell OptiPlex 755 User's Guide - Page 111
Network Controller, Installing a PCI Card in the Riser-Card Cage
View all Dell OptiPlex 755 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 111 highlights
12 If you removed a network adapter card: a Enter system setup, select Network Controller, and change the setting to On (see "Entering System Setup" on page 280). b Connect the network cable to the integrated network connector on the back panel of the computer. Installing a PCI Card in the Riser-Card Cage 1 Follow the procedures in "Before You Begin" on page 21. 2 Remove the computer cover (see "Removing the Computer Cover" on page 90). 3 If applicable, remove the card installed in the PCI3 connector on the system board. 4 Remove the riser-card cage: a Check any cables connected to cards through the back panel openings. Disconnect any cables that will not reach the riser-card cage once they are removed from the computer. b Gently pull on the handle and lift the riser-card cage up and away from the computer. 1 2 1 riser-card cage 2 handle Expansion Cards 111