Dell PowerConnect 7048P User Manual - Page 610

Configuring IP-Based VLANs Beginning in Privileged EXEC mode, use the following commands to associate an IP subnet with a configured VLAN. The VLAN does not need to be configured on the system to associate an IP subnet with it. You can create up to 256 VLAN to MAC address associations. Command Purpose configure Enter global configuration mode. vlan database Enter VLAN database mode. vlan association subnet Associate an IP subnet with a VLAN. ip-address subnet-mask • ip-address - Source IP address. (Range: Any valid IP vlanid address) • subnet-mask - Subnet mask. (Range: Any valid subnet mask) • vlanid - VLAN to associated with subnet. (Range: 14093) CTRL + Z Exit to Privileged EXEC mode. show vlan association subnet [ip-address ipmask ] Display the VLAN associated with a specific configured IPAddress and netmask. If no IP Address and net mask are specified, the VLAN associations of all the configured IPsubnets are displayed. Configuring a Protocol-Based VLAN Beginning in Privileged EXEC mode, use the following commands to create and name a protocol group, and associate VLANs with the protocol group. When you create a protocol group, the switch automatically assigns it a unique group ID number. The group ID is used for both configuration and script generation to identify the group in subsequent commands. A protocol group may have more than one interface associated with it, but each interface and protocol combination can be associated with one group only. If adding an interface to a group causes any conflicts with protocols currently associated with the group, adding the interface(s) to the group fails and no interfaces are added to the group. Ensure that the referenced VLAN is created prior to the creation of the protocol-based group except when GVRP is expected to create the VLAN. 610 Configuring VLANs