Dell PowerConnect 7048P User Manual - Page 970

Command Purpose default-information Control the advertisement of default routes. originate [always] [metric metric-value] • always - Normally, OSPF originates a default route only if a default route is redistributed into OSPF (and default- [metric-type type-value] information originate is configured). When the always option is configured, OSPF originates a default route, even if no default route is redistributed. • metric-value - The metric (or preference) value of the default route. (Range: 1-16777214) • type-value - The value is either 1 or 2: External type-1 route or External type-2 route. default-metric metric- Set a default for the metric of distributed routes (Range: value 1-16777214). distance ospf {external | Set the preference values of OSPF route types in the inter-area | intra-area } router. distance The range for the distance variable is 1-255. Lower route preference values are preferred when determining the best route. enable Enable OSPF. exit-overflow-interval Specify the exit overflow interval for OSPF as defined in seconds RFC 1765. The interval is the number of seconds after entering overflow state that a router will wait before attempting to leave the overflow state. (Range: 0-2147483647) external-lsdb-limit limit Configure the external LSDB limit for OSPF as defined in RFC 1765. If the value is -1, then there is no limit. The limit variable is the maximum number of non-default AS external-LSAs allowed in the router's link-state database. (Range: 1 to 2147483647) maximum-paths integer Set the number of paths that OSPF can report for a given destination (Range: 1-4). 970 Configuring OSPF and OSPFv3