Dell PowerConnect 7048P User Manual - Page 997

console(config-router)#area 0.0.0.1 stub console(config-router)#area 0.0.0.2 nssa 5 For IPv4: Enable OSPF for IPv4 on VLANs 10, 5, and 17 by globally defining the range of IP addresses associated with each interface, and then associating those ranges with Areas 1, 0, and 2, respectively. console(config-router)#network 10.1.2.0 0.0.0.255 area 0.0.0.1 console(config-router)#network 10.2.3.0 0.0.0.255 area 0.0.0.0 console(config-router)#network 10.2.4.0 0.0.0.255 area 0.0.0.2 6 For IPv4: Configure a metric cost to associate with static routes when they are redistributed via OSPF: console(config-router)#redistribute static metric 1 subnets console(config-router)#exit 7 For IPv6: Define an OSPF router. Define Area 1 as a stub and area 2 as a Not-So-Stubby-Area (NSSA). Configure a metric cost to associate with static routes when they are redistributed via OSPF: console(config)#ipv6 router ospf console(config-rtr)#router-id 2.2.2.2 console(config-rtr)#area 0.0.0.1 stub console(config-rtr)#area 0.0.0.2 nssa console(config-rtr)#redistribute static metric 105 metric-type 1 console(config-rtr)#exit Configuring a Virtual Link for OSPF and OSPFv3 In this example, Area 0 connects directly to Area 1. A virtual link is defined that traverses Area 1 and connects to Area 2. This example assumes other OSPF settings, such as area and interface configuration, have already been configured. Figure 34-37 illustrates the relevant components in this example OSPF configuration. Configuring OSPF and OSPFv3 997