Dell PowerConnect 7048P User Manual - Page 984

Command Purpose ipv6 ospf dead-interval seconds Set the OSPFv3 dead interval for the interface. The seconds variable indicates the number of seconds a router waits to see a neighbor router's Hello packets before declaring that the router is down (Range: 1-65535). This parameter must be the same for all routers attached to a network. This value should be some multiple of the Hello Interval. ipv6 ospf transmit-delay seconds Set the OSPFv3 Transit Delay for the interface. The seconds variable sets the estimated number of seconds it takes to transmit a link state update packet over this interface. (Range: 1-3600 seconds) ip ospf mtu-ignore Disable OSPFv3 MTU mismatch detection on received database description packets. ipv6 ospf network {broadcast | point-topoint } Set the OSPFv3 network type on the interface to broadcast or point-to-point. OSPFv3 selects a designated router and originates network LSAs only for broadcast networks. No more than two OSPFv3 routers may be present on a point-to-point link. ipv6 ospf cost interface- Set the metric cost of the interface. cost The interface-cost variable specifies the cost (link-state metric) of the OSPFv3 interface. (Range: 1-65535) bandwidth bw Set the interface bandwidth used in the formula to compute link cost for an interface: link cost = ref_bw÷interface bandwidth The bw variable is the interface bandwidth (Range: 1-10000000 Kbps). exit Exit to Global Configuration Mode ipv6 router ospf Enter OSPFv3 configuration mode. passive-interface {vlan Make an interface passive to prevent OSPFv3 from vlan-id | tunnel tunnel- forming an adjacency on an interface. OSPFv3 advertises id} networks attached to passive interfaces as stub networks. exit Exit to Global Config mode. exit Exit to Privileged EXEC mode. 984 Configuring OSPF and OSPFv3