Dell PowerConnect 7048P User Manual - Page 972

Command Purpose ip ospf area area-id [secondaries none] Enables OSPFv2 on the interface and sets the area ID of an interface. This command supersedes the effects of network area command. The area-id variable is the ID of the area (Range: IP address or decimal from 0 -4294967295) Use the secondaries none keyword to prevent the interface from advertising its secondary addresses into the OSPFv2 domain. ip ospf priority number- Set the OSPF priority for the interface. The number-value value variable specifies the priority of an interface (Range: 0 to 255). The default priority is 1, which is the highest router priority. A value of 0 indicates that the router is not eligible to become the designated router on this network. ip ospf retransmitinterval seconds Set the OSPF retransmit interval for the interface. The seconds variable is the number of seconds between link-state advertisements for adjacencies belonging to this router interface. This value is also used when retransmitting database descriptions and link-state request packets. Valid values range from 0 to 3600 seconds (1 hour). ip ospf hello-interval seconds Set the OSPF hello interval for the interface. This parameter must be the same for all routers attached to a network. The seconds variable indicates the number of seconds to wait before sending Hello packets from the interface. (Range: 1-65535). ip ospf dead-interval seconds Set the OSPF dead interval for the interface. The seconds variable indicates the number of seconds a router waits to see a neighbor router's Hello packets before declaring that the router is down (Range: 1-65535). This parameter must be the same for all routers attached to a network. This value should be some multiple of the Hello Interval. 972 Configuring OSPF and OSPFv3