Dell PowerConnect 7048P User Manual - Page 982

Command Purpose distance ospf {external | Set the preference values of OSPFv3 route types in the inter-area | intra-area } router. distance The range for the distance variable is 1-255. Lower route preference values are preferred when determining the best route. enable Enable OSPFv3. exit-overflow-interval Specify the exit overflow interval for OSPFv3 as defined in seconds RFC 1765. The interval is the number of seconds after entering overflow state that a router will wait before attempting to leave the overflow state. (Range: 0-2147483647) external-lsdb-limit limit Configure the external LSDB limit for OSPFv3 as defined in RFC 1765. If the value is -1, then there is no limit. The limit variable is the maximum number of non-default AS external-LSAs allowed in the router's link-state database. (Range: -1 to 2147483647) maximum-paths maxpaths Set the number of paths that OSPFv3 can report for a given destination. (Range: 1-4.) passive-interface default Configure OSPFv3 interfaces as passive by default. This command overrides any interface-level passive mode settings. OSPFv3 does not form adjacencies on passive interfaces but does advertise attached networks as stub networks. exit Exit to Global Configuration mode. exit Exit to Privileged EXEC mode. show ipv6 ospf View OSPFv3 global configuration and status. clear ipv6 ospf Reset specific OSPFv3 states. If no parameters are [{configuration | specified, OSPFv3 is disabled and then re-enabled. redistribution | counters | neighbor [interface vlan vlan-id [neighbor-id]]}] 982 Configuring OSPF and OSPFv3