Dell PowerConnect 7048P User Manual - Page 973

Command ip ospf transmit-delay seconds ip ospf mtu-ignore ip ospf network {broadcast | point-topoint} ip ospf authentication {none | {simple key} | {encrypt key key-id}} ip ospf cost interfacecost bandwidth bw exit router ospf passive-interface vlan vlan-id Purpose Set the OSPF Transit Delay for the interface. The seconds variable sets the estimated number of seconds it takes to transmit a link state update packet over this interface. (Range: 1-3600 seconds) Disable OSPF MTU mismatch detection on the received database description. Set the OSPF network type on the interface to broadcast or point-to-point. OSPF selects a designated router and originates network LSAs only for broadcast networks. No more than two OSPF routers may be present on a pointto-point link. Set the OSPF Authentication Type and Key for the specified interface. • encrypt - MD5 encrypted authentication key. • key - Authentication key for the specified interface. (Range: 8 bytes or less if the authentication type is simple and 16 bytes or less if the type is encrypt.) • key-id - Authentication key identifier for the authentication type encrypt. (Range: 0-25) Set the metric cost of the interface. The interface-cost variable specifies the cost (link-state metric) of the OSPF interface. (Range: 1-65535) Set the interface bandwidth used in the formula to compute link cost for an interface: link cost = ref_bw÷interface bandwidth The bw variable is the interface bandwidth (Range: 1-10000000 Kbps). Exit to Global Configuration Mode Enter OSPF configuration mode. Make an interface passive to prevent OSPF from forming an adjacency on an interface. OSPF advertises networks attached to passive interfaces as stub networks. Configuring OSPF and OSPFv3 973