Epson EPL-N1200 Service Manual - Page 30
Optional Serial Interface LocalTalk/Serial Module - epl 1200
View all Epson EPL-N1200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
General Description EPL-N1200 Service Manual 1.3.2 Optional Serial Interface (LocalTalk/Serial Module) The optional LocalTalk/Serial module contains serial interface with the following characteristics. Type: RS-232C or current loop Transfer system: Synchronization: Full duplex Asynchronous start-stop system Start-bit: 1 bit Stop-bit: 1 or 2 bits Data length: 7 bits or 8 bits Parity: Odd, even, or none Protocol: X-ON/X-OFF (can be combined with DTR control) DTR control (can be combined with X-ON/X-OFF) Transfer speed: 300, 600, 1200, 2400, 4800, 9600, 19200, 38400, or 57600 BPS Note 1: For RS-232C signal level, speeds of 38400 BPS and above place restrictions on the host computer, cable, and other operating conditions. Note 2 For current loop signal level, speeds of 2400 BPS and above place restrictions on the host computer, cable, and other operationg conditions. Error: Applicable plug Overrun error: Processed as missing data and replaced by "*" Parity error: Replaced by "*" Framing error: Replaced by "*" Breaking character: Ignored Circular miniature DIN 8-pin plug Signal Level (EIA BASED) : TXD, DTR Out put Voltage (VOH) 5 to 15 V (VOL) -5 to -15 V Open circuit voltage (VO) within +15 V Impedance with power off (rO) 300 ohms (MIN.) Load capacitance (CL) 2500 pF (MAX.) Through rate 30 V/u SEC (MAX.) Load resistance (Lo) 3 K to 7 K ohms RXD, CTS Input Voltage Input signal range Input impedance Imput current Open-circuit input voltage (VIH) (VIL) (RI) (II) (EL) 3 V (MIN.) -5 V (MIN.)*1) +25 V (MAX.)*1) 3 K to 7 K ohms + 8 mA (MAX)*1) -2 V (MAX>)*1) Note : Annotations "MIN". and "MAX." apply to absolute values. Signal descriptions: See Table 1-10. 1-18 Rev. A